Again, the width of the arrows should be double. Where you do show "Inlay Offset", it should show "Substrate Offset" and the value should be -9.2376. ![]() This is twice the width of the arrows you actually have. Your "Inlay Offset" caption should be to the left of the Profile line and the offset itself should be 4.6188, as shown by the calculator. You are measuring from the Profile line to the point of the cutter you need to go the same distance again to get to the other line that the V-cutter must follow. ![]() I think that the calculator is right, and that on your diagram, the ranges marked 2.31 and 4.62 are right, but that these are each half the intended offset for use in the offset tool.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |